How to use Hot Melt Adhesive Film for Mats

Nov 27, 2025

1. Prepare for use.

First, clean the mat and the ground surface to be bonded, removing dust, oil, and small impurities. Wipe them clean with a dry cloth to ensure there are no obstructions on the contact surface, which could affect the adhesion of the adhesive film. Check the storage condition of the adhesive film, confirming it is not damp, moldy, or damaged. If the adhesive film has hardened or stuck together, it needs to be replaced with a new one. At the same time, prepare the heating tools, ensuring they can be properly heated and that there is no oil residue on their surfaces, in preparation for subsequent operations.

TPU Hot Melt Adhesive Film

2. Precisely cut the film sizeBased on the size of the area to be covered by the floor mat, lay the adhesive film flat and mark the cutting area. Keep the blade sharp when cutting to ensure the edges of the film are flat and avoid rough edges or skewing. The size of the adhesive film must match the area to be covered; do not extend it excessively beyond the edge of the floor mat to prevent excess film from being exposed and affecting the appearance after application, and to avoid incomplete application due to insufficient size. After cutting, lay the adhesive film flat on the floor or the surface to be covered by the floor mat, adjusting its position to ensure precise alignment between the film and the area to be covered.

3. Perform heating and bonding in a standardized manner.Adjust the heating tool to the appropriate temperature for the adhesive film, and begin operation after the temperature stabilizes. If using an iron, place a cotton cloth over the adhesive film and move the iron slowly and evenly, from the center of the bonding area to the edge, ensuring the adhesive film is heated and melted evenly. If using a heat gun, maintain an appropriate distance and blow back and forth to avoid localized overheating that could cause the adhesive film to carbonize. During the heating process, gently press the mat or tool to ensure the molten adhesive film fully saturates the mat and bonding surface, expelling air bubbles and preventing them from affecting the adhesion.

4. Pay attention to post-use maintenance

After heating and bonding, allow the adhesive film to cool and cure naturally. Avoid moving or stepping on the mat during this time to prevent the incompletely cured film from detaching or shifting. After cooling, check the bonding effect for any curling edges, air bubbles, or areas that are not fully bonded. If small air bubbles are present, use a heating tool to heat the affected area again and gently press to release the air. If curling edges are present, clean off any residual adhesive film and re-cut and re-bond the mat. Avoid frequently dragging the mat during daily use and clean the surface regularly with a mild detergent to extend the adhesive film's lifespan.

If you are interested in China Tpu Hot Melt Adhesive Film For Textile Manufacturers and would like to obtain more detailed information, please feel free to contact Weitao Plastic New Material for in-depth consultation. We have a highly professional team that is always ready to listen attentively to your specific needs.

High tensile strength hot melt adhesive film

You Might Also Like